Use; Operation - clage Zip HydroTap G5 BC 20 Gebrauchs- Und Montageanleitung

5. Use

Hot water lever Cold water lever
White filter LED
Boiling, chilled
water
SELECT
SAFETY
Zip lever
Note: If the water system has not been used for several days, allow the tap to run
cold water for about five minutes.

Operation

Classic
Press the red lever to dispense hot water (max. 15 sec.). Pull the lever up to dispense
hot water continually. The water will flow for 5 to 15 seconds. This time can be set in
the menu. The lever then has to be manually returned to the Off position.
Press the blue lever to dispense chilled water (max. 15 sec.). Pull the lever up to
dispense chilled water continually. The water will flow for 5 to 15 seconds. This time
can be set in the menu. The lever then has to be manually returned to the Off position.
Classic Plus
Press the red button to dispense hot water. When the button is pressed, hot water
flows as long as it is pressed (max. 15 sec.).
Press the blue button to dispense chilled water. When the button is pressed, chilled
water flows as long as it is pressed (max. 15 sec.).
Quantity filling: Before selecting the water type, press the fill button. After pressing the
red, blue or white button briefly, water flows for a period of between 5 and 15 seconds
that can be set in the menu.
Touch-Free
Hold your hand approx. 1.5 – 5 cm in front of the left and rear sensors to dispense hot
water. Hot water flows as long as the hand is held in the sensor area (max. 15 sec.).
Hold your hand approx. 1.5 – 5 cm in front of the right sensor to dispense cooled water.
Chilled water flows as long as the hand is held in the sensor area (max. 15 sec.). If the
rear sensor is also triggered, water flows for a period of between 5 and 15 seconds that
can be set in the menu.
Note: To ensure smooth functioning of the sensor tap, make sure there is a free
space of min. 10 cm around the sensor head.
Arc
Select the desired type of water by tipping to on the Select button on the ZIP lever at
the tap.
• Red: boiling water
• Blue: chilled water
Turn the lever to dispense water. When the lever is turned counterclockwise, water will
flow as long as the lever is held (max. 15 sec.). If the lever is turned clockwise, water
will flow continually for 5 to 15 seconds. This time can be set in the menu. The lever
then has to be manually returned to the Off position.
Red light (Arc / Classic Plus / Classic)
• On all the time: boiling water is ready and can be dispensed.
• Flashing: the water has not yet been heated to the set temperature.
Blue light (Arc / Classic Plus / Classic)
• On all the time: temperature of chilled water is at the set temperature.
• Flashing: the water has not yet been chilled to the set temperature.
White filter LED (Classic)
• Flashing: the filter needs to be replaced. This LED starts flashing according to filter
use and the filter capacity set in the menu.
Note: For the tap Arc the need for a filter replacement is indicated by cyclically
flashing all the LEDs in all three colours
25
CLAGE
EN