JUNO JB121D0 Benutzerinformation Seite 14

14
4. Press or the Duration starts
automatically after 5 seconds.
5. Press or
Duration.
6. Press or the Duration starts
automatically after 5 seconds.
When the set time ends, the signal sounds
for 2 minutes. The display shows flashing
and time setting. The oven turns off.
7. Press a sensor field to stop the signal.
8. Turn off the oven.
How to set: End Time
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press or
and press . First you set the
minutes and then the hours.
When the set time ends, the signal sounds
for 2 minutes. The display shows flashing
and the time setting . The oven turns
off automatically.
4. Press a sensor field to stop the signal.
5. Turn off the oven.
How to set: Time Delay
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press or
Duration.
4. Press .
5. Press or
Duration.
6. Press .
The display shows flashing
7. Press or
and press . First you set the
minutes and then the hours.
The oven turns on automatically later on,
works for the set Durationand stops at the
set End Time. When the set time ends, the
to set the hours for
to set the End Time
to setthe minutes for
to set the hours for
.
to set the End Time
signal sounds for 2 minutes. The display
shows flashing
The oven turns off automatically.
8. Press a sensor field to stop the signal.
9. Turn off the oven.
When the Time Delay function
is turned on, the display shows
a symbol of the heating
function,
The dot shows which clock
function is on in the Clock /
residual heat display.
How to set: Set + Go
You can use the Set + Go function only
when the Duration is set.
1. Set a heating function and
temperature.
2. Set the Duration.
3. Press again and again until the
display shows flashing
4. Press to set the Set + Go function.
The display shows
indicator. This indicator shows which clock
function is activated.
5. Press a sensor field (apart from ON /
OFF) to start the Set + Go function.
How to set: Minute Minder
1. Press .
The display shows flashing
2. Press to switch between options.
First you set the seconds, then the
minutes and the hours.
3. Press or
Minder and
4. Press or the Minute Minder starts
automatically after 5 seconds.
When the set time ends, the signal sounds
for 2 minutes and the display shows
flashing 00:00 and
5. Press a sensor field to stop the signal.
and the time setting .
with a dot and
.
and with an
and "00".
to set the Minute
to confirm.
.
.