Cleaning The Tool - Makita DUR193 Betriebsanleitung

Cleaning the tool

Clean the tool by wiping off dust, dirt, or cut off grass
with a dry cloth or one dipped in soapy water and wrung
out. If the cut off grass is adhered to the motor housing,
be sure to remove it.
► Fig.27: 1. Motor housing
Replacing the nylon cord
WARNING:
Use nylon cord with diameter specified in "SPECIFICATIONS" only. Never use heavier line,
metal wire, rope or the like. Use recommended nylon cord only, otherwise it may cause damage to the tool and
result in serious personal injury.
WARNING:
Make sure that the cover of the nylon cutting head is secured to the housing properly as
described below. Failure to properly secure the cover may cause the nylon cutting head to fly apart resulting in
serious personal injury.
CAUTION:
When installing or removing the nylon cord, be careful not to contact the nylon cord cutter
on the protector. Contact with the cutter may result in personal injury.
Replace the nylon cord if the cord is not feeding any more.
► Fig.30: (1) Up to 8 m (2) 70 - 80 mm
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
It does not reach maximum RPM.
Cutting tool does not rotate:
stop the machine immediately!
Abnormal vibration:
stop the machine immediately!
Cutting tool and motor cannot stop:
Remove the battery immediately!
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
Foreign object such as a branch is
jammed between the guard and the
cutting tool.
The drive system does not work
correctly.
One end of the nylon cord has been
broken.
The drive system does not work
correctly.
Electric or electronic malfunction.
16 ENGLISH
Storage
When storing the tool, raise the wire guard, shorten the
shaft, and then fold the loop handle.
► Fig.28: 1. Wire guard
► Fig.29: 1. Loop handle 2. Shaft
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using of tool to allow it to cool down.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Remove the foreign object.
Ask your local authorized service center for repair.
Tap the nylon cutting head against the ground while
it is rotating to cause the cord to feed.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
service center for repair.