Assembly And Adjustment - DeWalt DW331 Originalanweisungen

EN GLI SH
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power
input of this tool (see technical data).The minimum
conductor size is 1.5 mm 2 ; the maximum length is
30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENT

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Fitting and removing a saw blade (fig. B)
The tool-free blade exchange system ensures quick
and easy changing of saw blades.
• Open the blade holder (7) by fully retracting the
blade latch (5).
• Insert the saw blade into the blade holder (7)
guiding the back of the blade into the groove of
the guide roller (8).
• Release the blade latch (5).
• To remove the saw blade, fully retract the blade
latch and pull the blade out of the holder.
Saw blades
Blade type
Fine-toothed cutting blade for smooth straight cuts
Coarse-toothed cutting blade for fast straight cuts
Metal cutting blade for ferrous and non-
ferrous metals
Flush cutting blade* for finishing off cuts up to a
wall or edge.
* Not available in all countries.
28
A wide variety of dedicated saw blades is available
as an option.
Setting the bevel angle (fig. C)
The adjustable shoe (9) allows cutting of LH and RH
bevel angles up to 45°. The bevel scale has preset
positions at 0°, 15°, 30° and 45°.
• Release the shoe lever (11).
• Slide the shoe (9) toward the saw blade.
• Tilt the shoe and set the desired bevel angle
• Tighten the shoe lever.
Setting the pendulum stroke (fig. A)
The adjustable pendulum stroke guarantees a
perfect cutting stroke for different materials.
• Slide the selector (10) to the desired position
Pos.
3
2
1
0
Setting the sawdust blower (fig. A)
The sawdust blower conducts an adjustable stream
of air to the saw blade to keep the workpiece clear
of sawdust during operation.
• Set the sawdust blower using the lever (4).
Applications
WARNING: Always select your saw
blade with great care.
using the scale.
referring to the table below. The selector can be
manipulated during operation.
Wood Metal
Fast cuts -
Thick workpieces -
Plywood Aluminium
Chipboard Non-ferrous
Thin workpieces Sheet metal
Fine cuts
- Low For working with metals, when
using coolants and lubricants
and for use with dust extraction.
- Intermediate For working with wood and
similar materials in low speed.
- High For working with wood and
similar materials in high speed.
Plastics
PVC
Fibreglass
Acrylic
-
-
-