Assembly And Adjustment - DeWalt DW937 Anweisungen

E N G L I S H

Assembly and adjustment

Prior to assembly and adjustment,
always remove the battery pack.
Always switch OFF the tool before
inserting or removing the battery pack.
Battery pack (fig. A)
Charging the battery pack
When charging the battery pack for the first time,
or after prolonged storage, it will only accept an 80%
charge. After several charge and discharge cycles,
the battery pack will attain full capacity. Always check
the mains prior to charging the battery pack. If the
mains is functioning but the battery pack does not
charge, take your charger to an authorised D
repair agent. Whilst charging, the charger and the
battery pack may become warm to touch. This is a
normal condition and does not indicate a problem.
Do not charge the battery pack at
ambient temperatures <4 °C or >40 °C.
Recommended charging temperature:
approx. 24 °C.
• To charge the battery pack (7), insert it into the
charger (9) as shown and plug in the charger.
Be sure that the battery pack is fully seated in the
charger. The red charging indicator (10) will blink.
After approx. 1 hour, it will stop blinking and
remain on. The battery pack is now fully charged.
The battery pack can be removed at any time or
left in the connected charger indefinitely.
Inserting and removing the battery pack
• Insert the battery pack into the grip until it clicks
in place.
• To remove the battery pack, press the two
release buttons (8) simultaneously and pull the
pack out of the grip.
Replacing the saw blade (fig. B)
• Move the blade clamp slider (12) up to release
the blade clamping mechanism.
• Insert the saw blade into the holder (11) until it
engages. The blade can be installed with the
teeth pointing down or up.
en - 5
• Move the blade clamp slider (12) down to lock
the blade clamping mechanism.
• To remove the saw blade, proceed in reverse
order.
Saw blades
material
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available
as an option.
WALT
E
Instructions for use
Prior to operation:
• Mount the appropriate type of saw blade.
Use narrow saw blades for cutting curves.
Use flexible bimetal saw blades for hard-to-reach
positions (e.g. close to walls, etc.).
• Make sure your battery pack is (fully) charged.
Switching ON and OFF (fig. A)
For safety reasons the variable speed switch (1) is
equipped with a lock-off button (2).
• Press the lock-off button (2) to the left to unlock
the tool.
recommended saw blade
fine-toothed
coarse-toothed
TCT saw blade
fine-toothed
carbide-tipped
Always select your saw blade with
great care.
• Always observe the safety instructions
and applicable regulations.
• Ensure the material to be sawn is
secured in place.
• Apply only a gentle pressure to the tool
and do not exert side pressure on the
saw blade. If possible, work with the saw
shoe pressed against the workpiece.
This prevents damage to the blade and
stops the tool from jerking and vibrating.
• When sawing in walls or floors be aware
of the location of pipework and wiring.
Always hold the tool by its handle.
• Avoid overloading.
20