Assembly And Adjustment; Using An Extension Cable - DeWalt DW310 Anweisungen

E N G L I S H
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.

Using an extension cable

If an extension cable is required, use an approved
extension cable suitable for the power input of this
machine (see technical data). The minimum
conductor size is 1.5 mm
rubber jacket and a grounding conductor.
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
22
2
. The cable has to have a
Conductor size (mm
0.75
1.00
1.50
2.50
4.00
Voltage Amperes
115 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0

Assembly and adjustment

Prior to assembly and adjustment always
unplug the tool.
Mounting the saw blade (fig. B)
• Open the blade clamp collar (7) to release the
blade clamping mechanism.
• Insert the saw blade (8) into the holder (4) until it
engages. The blade can be installed with the
.
teeth pointing down or up.
• Close the blade clamp collar (7) to lock the blade
clamping mechanism.
• To remove the saw blade, proceed in reverse
order.
Saw blades
material
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available
as an option.
2
) Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5 15 25 30
Cable rating (Amperes)
6 6 6 6
6 6 6 6
6 6 10 15
10 10 15 20
15 15 20 25
20 20 25 -
6 6 6 6
6 6 6 6
6 6 6 6
10 10 10 10
15 15 15 15
20 20 20 20
recommended saw blade
fine-toothed
coarse-toothed
coarse-toothed
fine-toothed
carbide-tipped
45 60
6 10
15 15
20 20
20 25
25 -
- -
6 6
6 6
10 15
15 15
20 20
25 -