Using An Extension Cable; Electrical Safety - DeWalt DC385 Originalanweisungen

Description (fi g. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Variable speed switch
b. Lock-off button
c. Blade clamp lever
d. Saw shoe
e. Battery pack
f. Battery release buttons
g. Main handle
h. Charger
i. Charging indicator (red)
INTENDED USE
Your DC385 cordless reciprocating saw has been
designed for professional sawing of wood, metal
and tubes. The compact design permits cutting
extremely close to the edge of difficult areas.
DO NOT use under humid conditions or in presence
of flammable liquids or gases.
The DC385 cordless reciprocating saw is
professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.

Using an Extension Cable

An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENT
WARNING: Prior to assembly and
adjustment, always remove the
battery pack. Always switch off the
tool before inserting or removing the
battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fi g. 1)
1. Insert the battery pack (e) into the grip until it
clicks in place.
2. To remove the battery pack, press the two
battery release buttons (f) simultaneously and
pull the pack out of the grip.
Replacing the Saw Blade (fi g. 3, 4)
1. Move the blade clamp lever (c) up to release the
blade clamping mechanism.
2. Insert the saw blade into the holder (k) until it
engages. The blade can be installed with the
teeth pointing down, up, left or right, as shown
in figure 4.
3. Move the blade clamp lever (c) down to lock the
blade clamping mechanism.
4. To remove the saw blade, proceed in reverse
order.
SAW BLADES
material recommended saw blade
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available
as an option.
EN GL IS H
WALT battery
E
fine-toothed
coarse-toothed
coarse-toothed
fine-toothed
carbide-tipped
35