Prior To Operation - DeWalt D23550 Originalanweisungen

EN GLI SH
MOUNTING
1. Slacken the locking screw (v) as to allow the
parallel fence to pass.
2. Insert the parallel fence (o) in the saw shoe (f) as
shown.
3. Tighten the locking screw (v).
ADJUSTING
1. Slacken the locking screw (v) and set the
parallel fence (o) to the desired width.
2. Tighten the locking screw (v).

Prior to Operation

– Make sure the guards have been mounted
correctly. The saw blade guard must be in
closed position.
– Make sure the saw blade rotates in the direction
of the arrow on the blade.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Ensure the material to be sawn is
firmly secured in place.
• Apply only a gentle pressure to the
tool and do not exert side pressure on
the saw blade.
• Avoid overloading.
• Do not use excessively worn saw
blades.
• Do not use your saw for pocket cuts.
Proper Hand Position (fi g. 1, 8)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
34
Proper hand position requires one hand on the main
handle (x) with the other hand on the front handle (c).
Switching On and Off (fi g. 1, 2)
For safety reasons the trigger switch (a) of your tool
is equipped with a lock-off button (b).
1. Press the lock-off button to unlock the tool.
2. Press the trigger switch (a) to run the tool.
As soon as the trigger switch is released the
lock-off switch is automatically activated to
prevent unintended starting of the machine.
WARNING:
• Do not switch the tool on or off when
the saw blade touches the workpiece
or other materials.
• Do not operate the spindle lock while
the tool is running.
Guiding the Tool (fi g. 1, 2)
• For optimum results, clamp the workpiece
bottom up.
• Follow the line drawn on the workpiece using
the mark (m).
• In case of a bevel angle of 45°, follow the line
drawn on the workpiece using the mark (l).
WARNING: ALWAYS lead the cord
away in line with the rear of the tool
Dust Extraction (fi g. 1)
WARNING: Risk of dust inhalation.
To reduce the risk of personal injury,
ALWAYS wear an approved dust mask.
Your tool is fitted with a dust extraction outlet (e).
Whenever possible, connect a dust extraction device
designed in accordance with the relevant regulations
regarding dust emission.
WARNING: ALWAYS use a vacuum
extractor designed in compliance with
the applicable directives regarding dust
emission when sawing wood. Vacuum
hoses of most common vacuum
cleaners will fit directly into the dust
extraction outlet.
WARNING: Do not use a vacuum
extractor without proper spark
protection when sawing metal..