Assembly And Adjustments; Prior To Operation - DeWalt DW310 Originalanweisungen

EN GLI SH
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Mounting the Saw Blade (fi g. 2)
1. Open the blade clamp collar (g) to release the
blade clamping mechanism.
2. Insert the saw blade (h) into the holder (d) until
it engages. The blade can be installed with the
teeth pointing down or up.
3. Close the blade clamp collar (g) to lock the
blade clamping mechanism.
To remove the saw blade, proceed in reverse order.
Saw Blades
material recommended saw blade
ferrous metal fine-toothed
non ferrous metal coarse-toothed
wood coarse-toothed
plastic fine-toothed
masonry carbide-tipped
A wide variety of dedicated saw blades is available
as an option.
WARNING: Always select your saw
blade with great care.
Setting the Adjustable Saw Shoe
(fi g. 3)
The saw shoe can be adjusted to limit the depth of
cut and prolong the life of your saw blade.
1. Push the release lever (f) down.
2. Slide the saw shoe (e) into the desired position.
3. Push the lever up to secure the shoe in place.
SETTING THE PENDULUM STROKE (FIG. 4)
DW311
The adjustable pendulum stroke guarantees a
perfect cutting stroke for different materials. The tool
can be used in the following operating modes:
Straight reciprocating motion: for cutting
metal and tubes and for finishing wood.
24
Orbital motion: for fast cutting of wood.
• Turn the selector (c) into the required position
aligning the mark (i) with the arrow (j).

Prior to Operation

Mount the appropriate type of saw blade. Use
narrow saw blades for cutting curves. Use flexible
bimetal saw blades for hard-to-reach positions (e.g.
close to walls, etc.).
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Ensure the material to be sawn is
secured in place.
• Apply only a gentle pressure to the
tool and do not exert side pressure
on the saw blade. If possible, work
with the saw shoe pressed against
the workpiece. This prevents damage
to the blade and stops the tool from
jerking and vibrating.
• When sawing in walls or floors be
aware of the location of pipework and
wiring. Always hold the tool by its
handle.
• Avoid overloading.
• Let the blade run freely for a few
seconds before starting the cut. Never
switch on the tool when the saw
blade is jammed in the workpiece or in
contact with the material.
Proper Hand Position (fi g. 1, 6)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.