Ptz Setup - SKYTRONIC 351.115 Gebrauchsanleitung

Picture 5- 29a
If you can't receive email alarm information successfully, please check below points:
DVR connection is normal or not;
The receiver and sender email support SMTP protocols or not;
Emails account setting is correct or not;
Email alarm parameters configuration is right or not;
DVR is on the status of I/O alarm or Motion detection or not.

5.3.6.3 PTZ setup

Enter into [Main menu Device
(Pelco-D or Pelco-P), Baud Rate (1200, 2400, 4800, 9600), Data bit (8, 7, 6, 5), Stop bit (1, 2), Parity Check (None,
Odd, Even, Mark, Space), Address Code and Cruise status respectively.
PTZ Setup] to select the channel you desire to control and set PTZ protocol
Picture5-30
Picture 5-28
Picture5-31
Picture 5-29b