Alarm Setup - SKYTRONIC 351.115 Gebrauchsanleitung

When you install a HDD, the system will automatically detect if HDD is formatted or not; If HDD needs
to be formatted, HDD status will be shown as "Not format/No disk", otherwise, the HDD status will be
shown as "Normal" (refer to Picture 5-24). NO：HDD number defaulted by system
State：Available Hard drive. You could use HDD only when formatting the HDD and inspect its status
normal.
TOTAL SPACE: Indicates total space available on Hard Drive.
AVAIL SPACE: Indicates unused space available on the Hard Drive.
USEABLE REC TIME: Based on current image detail/quality and frame rate, system will show you
how many Recording time you have left on the Hard Drive.
OVERWRITE: If you select "on" the system will automatically overwrite the oldest recordings once the hard
drive is full; if you select "off", recording will stop once the hard drive is full.
HDD FORMAT: You use this option to format the hard drive, you can not record files to the hard drive until it
has been formatted. Click [Format HDD] button to start formatting. When selecting [Format HDD] option the system
will prompt you – "Format HDD will loss all the data, do you confirm?" ; click "OK", system will prompt you – "Is
formatting..." and "successful format"; and then system will restart automatically.
USB FORMAT: Use this option to format USB devices (Is strongly recommended).

5.3.6.2 Alarm Setup

Click [Main Menu Device
5-25a). Click [Alarm Config] on the bottom of the [Alarm setup] screen to enter into the interface shown as Picture
5-25(b).Now you are allowed to set detailed alarm parameters.
I/O STATUS：Options include NO (Normal-open), NC (Normal-close) and OFF. Set to "Normal-open" if you use
external sensor alarms that are normally open, Set to "Normal-close" if you use external sensor alarms that are
normally closed, set to "off" if you are not going to use external sensor alarms. You can use the DVRs internal
motion detection to record when motion is detected; you do not external sensors to record on motion detection.
HDD LOSS: Options are On and Off. If you select On there will be a buzzer sound and "H" sign on screen when
HDD is not detected or not formatted; on the contrary, if you close the function, there is only "H" sign to indicate
HDD not found, but no alarm sound when HDD not found or not formatted.
HDD SPACE: Options are On and Off. When the alarm function is on, there are alarm sounds when the HDD
is running out of space; when the function is off, there are no alarm sounds.
VIDEO LOSS: Options are On and Off. When the function is on, system will issue alarm sound and display
video loss on the preview interface; when the function is off, system will have no alarm sound, but the preview
interface will display video loss.
ALARM MANAGE：Alarm Output（0s,10s,20s,40s,60s） 、Buzzer time (0s,10s,20,40s,60s) and alarm duration
time（0s, 30s, 1minute，2minute，5minute） 。
Pre-record time: you can set how long record will last before alarm occurs (Off, on).
Full screen Alarm: The function is defaulted to "On". When the motion detection or external alarm is triggered,
the corresponding channel will be displayed on the full screen mode.
Email：The option allows you set the alarm images is issued to a specified email or not.
Alarm] to enter into [Alarm setup] menu to setup Alarm warnings (shown as Picture
Picture 5-25（a） Picture 5-25（b）