Ptz Control; Stop Recording - SKYTRONIC 4CH Gebrauchsanleitung

5.5 PTZ Control

Picture 5-49
Cruise Set
Open auto cruise function on PTZ setting menu if you want to setup cruise function (system default: on), and
set up cruise channel, cur point and total quantity and stop time etc.
Set: save the preset point. After setting channel and setting the position by adjusting PTZ direction key you click
[Set] button to setup the pre-set point. Please note you will click the [Save] button to finish the setting successfully.
If you want to combine Zoom, Iris, Focus and direction keys into the pre-set setting, please return to previous
menu (shown as Picture 5-56) to add additional settings, and then enter into Cruise Set again and click [Set] and
[Save] to make sure your setting is setup successfully.
Clean: remove settings.
Note: this DVR model supports up to 100 pre-set points. But actual quantities may be restricted by the PTZ
camera you are using.
5.6 Record
When you want the system to start recording click [ Rec ] button to start manual recording.

5.7 Stop recording

If you want to stop manual recording click [Stop Record.] menu or [Stop] button
We introduced setting PTZ parameters previously in chapter 5.2.6.3.
Here we will discuss how to operate PTZ controls.
Click pop-up menu to show PTZ option and enter into PTZ control
interface (shown as Picture 5-49). You can now click Z+&Z- keys to zoom In
or out, click F+&F- keys to control camera focus and click I+&I- to adjust iris.
Channel select: select the channel with the PTZ camera
Total: set up presetting bit quantity
Cur Point: System has default starting (current) cruise point as 01. You
can use this option to set additional cruise points.
Stop time: sets the pause time at each stop.
GOTO：select this option to go to specific preset points