Ptz Setup - SKYTRONIC 351.142 Gebrauchsanleitung

Picture 5- 29a
If you can't receive email alarm information successfully, please check below points:
 DVR connection is normal or not;
 The receiver and sender email support SMTP protocols or not;
 Emails account setting is correct or not;
 Email alarm parameters configuration is right or not;
 DVR is on the status of I/O alarm or Motion detection or not.

5.3.6.3 PTZ setup

Enter into [Main menuDevice PTZ Setup] to select the channel you desire to control and set PTZ protocol
(Pelco-D or Pelco-P), Baud Rate (1200, 2400, 4800, 9600), Data bit (8, 7, 6, 5), Stop bit (1, 2), Parity Check (None,
Odd, Even, Mark, Space), Address Code and Cruise status respectively.
Picture5-30
Picture 5-28
Picture5-31
Picture 5-29b