Chapter 3: Dvr Installation; Hard Drive Installation; Camera And Monitor Connection; Power Supply Connection - SKYTRONIC 351.115 Gebrauchsanleitung

3.1 Hard Drive Installation

Caution： Please do not Install or take out hard drive when DVR is running!
(1) Remove screws on two sides of the body and open DVR upper cover carefully;
(2) Some models has a HDD Drawer; Use provided key to take out . Insert Power Cord and data cable into Pin of
hard drive securely;
(3) Put the upper cover back carefully, re-attach screws.

3.2 Camera and Monitor Connection

Connect camera cable to video input of DVR, and from video output of DVR to Monitor via BNC connector
(Refer to section2.2-Rear Panel); or
If the camera is a PTZ speed dome, you could connect RS485 A & B to the according port of DVR respectively
(refer to system figuration on Chapter 8).

3.3 Power Supply connection

Please only use the power adapter supplied with the DVR .

Chapter 3: DVR Installation