Lithium Battery Connection Diagram - H-Speed Herakles Mini Bedienungsanleitung

LITHIUM BATTERY CONNECTION DIAGRAM

PLEASE NOTE:
The charger MUST be powered before you connect a battery to the charger, failure
to have the charger powered up before connecting a battery can cause charger
failure if any connections are incorrect. The charger must be powered in order to
recognize an incorrect connection and warn you of this before you can go too far
and cause damage. If you get the warning "Reverse Polarity" you MUST disconnect
the battery immediately! Never remove power from the charger first.
1. Connect charge leads to the charger, making sure polarity of all leads is correct.
2. Turn the charger on and check your settings that they match the battery pack
you intend to charge.
3. Connect the main leads of the battery to the main leads of the charger.
4. Connect the balance lead of the battery to the correct balance port on the multi
balance board. If in doubt as to which socket to use please ask your dealer for
clarification.
5. Start the charge cycle, wait and watch that the charger starts to charge and
shows correct readings on the screen.
6. When charging is finished disconnect
the balance lead from the board, then
disconnect the battery main leads from
the charging lead.
This diagram shows the correct way
to connect your battery to the
HERAKLES MINI while charging in
the balance charge program mode only.
WARNING!
Failure to connect will damage this charger.
EN 36