BestMatic SBS-126287.2 Bedienungsanleitung Seite 14

4. Ensure that all the doors are wedged open slightly to allow air to circulate.
CLEANING AND CARE
For hygienic reasons the appliance (including exterior and interior accessories) should be cleaned regularly at
least every two months.
WARNING: The appliance must not be connected to the mains during cleaning. Danger of electrical shock!
Before cleaning, switch the appliance off and remove the plug from the mains socket.
Exterior cleaning
• To maintain good appearance of your appliance, you should clean it regularly.
• Wipe the digital panel and display panel with a clean, soft cloth.
• Spray water onto the cleaning cloth instead of spraying directly on the surface of the appliance. This helps
ensure an even distribution of moisture to the surface.
• Clean the doors, handles and cabinet surfaces with a mild detergent and then wiped dry with a soft cloth.
• When cleaning door sealing strip, always use clean water, wipe with dry cloth and let it dry naturally.
Caution!
Don't use sharp objects as they are likely to scratch the surface. Don't use Thinner, Car detergent, Clorox,
ethereal oil, abrasive cleansers or organic solvent such as Benzene for cleaning. They may damage the surface
of the appliance and may cause fire.
Interior cleaning
You should clean the appliance interior regularly. It will be easier to clean when food stocks are low. Wipe the
inside of the fridge freezer with a weak solution of bicarbonate of soda, and then rinse with warm water using
a wrung-out sponge or cloth. Wipe completely dry before replacing the shelves and baskets. Thoroughly dry all
surfaces and removable parts.
Defrosting:
This production has automatic defrosting function, without manual operation.
Replacing the LED light
Warning: the LED light must not be replaced by the user! If the LED light is damaged, contact an authorized
service representative for repairing.
WATER DISPENSER
Instructions for child lock lever
There is a child lock lever ① under the child lock icon.
Press the child lock lever with your thumb as the direction as below ① , and
the water lever ② will be locked to prevent children from taking any water.
Press in the opposite direction to unlock and take water.
•
Push in the lever of the water dispenser with your glass.
•
Releasing the lever, stops further dispensing of water.
•
Flow rate is dependent on how far the lever is pushed back:
Fully back = full flow
Gently back = trickle
•
As the level of water in your cup/glass rises, gently reduce the amount of pressure on the lever to avoid
overflow.
Notes: Push the water dispenser lever with a rigid cup. If you are using a plastic disposable cup, then push the
lever with your fingers from behind the cup.
Instructions for water tank assembly
1. Hold both sides of the tank with hands and pull the tank assembly off the door slightly in the direction
indicated as below.
Notes: The transparent silicone parts of the sealed water valve could be brought out meantime when
removing the water tank. If so, remove them, and re-install them according to the following steps.
- 13 -