Herunterladen Inhalt Inhalt Diese Seite drucken

Service & Maintenance - Ferm HGM1004 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für HGM1004:
Inhaltsverzeichnis

Werbung

.
.
-
.
,
.
.
,
.
,
.
.
.
OFF (
.
/
,
.
,
.
,
(
,
,
)
.
-
.
-
.
/
(on/off).
.
60
.
Ferm.
Ferm
.
-
'
-
!
,
.
)
.
.
,
(
).
240 volt.
.
-
.
.
!
that the battery is faulty and may only be temporary.
However, if the liquid comes into contact with your
skin or clothes, wash the affected area quickly in
warm, soapy water.
If the liquid gets in your eyes, wash your eyes with
clean cool water for a minimum of 10 minutes and
seek medical attention immediately afterwards.
Never throw your battery on a fire.
3. ASSEMBLY
Charging your battery pack
Charge your battery fully before use. Charge time
.
approximately 1 hour.
!
IMPORTANT:
Do not charge your battery in a very cold room (below
5ºC) or above 40 ºC (104F).
4. USE
Using your battery charger
Inspect your charger carefully and if any faults are
detected return it to your point of purchase. Failure
to do so could lead to personal injury.
Insert your battery into the charger - it will only fit
.
one way. When the indicator light is red, the battery
,
is charging. When the indicator light is green, the
.
battery is fully charged. Charge time approximately
1 hour.
Using your hedge trimmer
For your own safety and for best results read the
following user advice and do not use this product for
anything other than its intended purpose.
Switching ON and OFF
To switch the trimmer on, press the ON/OFF trigger
(1) and the start switch (2) at the same time.
To switch off, release one or both switches.
Note: If you notice a slight burning smell, it is nothing to
worry about. It is the electric brake working.
Trimming a hedge - best method
Ideally a hedge should be wider at the bottom than
the top. This will improve light penetration, keeping
230 -
the hedge healthy.
If possible, trim both sides of the hedge.
When trimming the sides of the hedge, trim from the
bottom upwards. This will ensure there are no hedge
.
trimmings obscuring or interfering with your cut
strokes.
The blade should not be forced to cut too deep. Cut
lightly through the surface of the hedge.
When trimming the top of the hedge, trim away from
you but do not over-reach. It is much wiser and safer
to move along and cut within your reach remaining
on two feet at all times.
,
Ferm
Ferm
WARNING!
Do not let the blade come into contact with wire
meshing or fencing material. It could damage the
material and your trimmer.
5. SERVICE & MAINTENANCE
Cleaning
To reduce the risk of electric shock the charger must be
unplugged from the power supply and the battery
removed before cleaning (or maintaining) the charger.
Lubrication
The machine requires no additional lubrication.
Environment
You battery contains materials that are considered
toxic. Dispose of the battery through an
environmentally safe waste disposal centre.
Faults
Should you experience any problems at all with this
product or require spare parts, ring your nearest
authorised dealer.
Warranty
The warranty conditions can be found on the separately
enclosed warranty card. Wear of the hedge trimmer is
not covered by the warranty.
ı
( UK )
CE
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product conforms with the following standards or
standardised documents:
EN 60335-1, EN 60335-2-29, EN 60745-1,
Din EN ISO 10517, EN 55014-1,
EN 55014-2, EN 61000-3-2, EN 61000-3-3
in accordance with regulations:
98/37/EEC, 73/23/EEC, 89/336/EEC,
01-01-2004
ZWOLLE NL
W. Kamphof
Quality Department
It is our policy to continuously improve our products
and we therefore reserve the right to change the
product specification without prior notice.
Ferm B.V, Zwolle, The Netherlands
5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Fcht-1800/2

Inhaltsverzeichnis