IKEA UDDARP AA-2307002-2 Bedienungsanleitung Seite 6

ENGLISH
During the drying phase, the door
tends to get quite hot.
Do not use the appliance to dry clothes
that have been washed with flammable
solvents (e.g. trichlorethylene).
Do not use the appliance to dry foam
rubber or similar elastomers.
Make sure that the water tap is turned
on during the drying cycles.
Remove all objects from pockets such
as lighters and matches.
INSTALLATION
The appliance must be handled and
installed by two or more persons - risk of
injury. Use protective gloves to unpack and
install - risk of cuts.
If you want to stack a dryer on top of your
washing machine, first contact our Stores
or your specialist dealer to verify whether
this is possible. This is only possible if the
dryer is attached to the washing machine
by means of appropriate stacking kit
available through our Stores or your
specialist dealer.
Move the appliance without lifting it by
the worktop or top lid.
Installation, including water supply
(if any) and electrical connections and
repairs must be carried out by a qualified
technician. Do not repair or replace any
part of the appliance unless specifically
stated in the user manual. Keep children
away from the installation site.
After unpacking the appliance, make sure
that it has not been damaged during
transport. Once installed, packaging
waste (plastic, styrofoam parts etc.) must
be stored out of reach of children - risk
of suffocation. The appliance must be
disconnected from the power supply
before any installation operation - risk of
electric shock. During installation, make
sure the appliance does not damage the
power cable - risk of fire or electric shock.
Only activate the appliance when the
installation has been completed.
Do not install your appliance where it
may be exposed to extreme conditions,
such as: poor ventilation, temperatures
below 5°C or above 35°C.
When installing the appliance make
sure that the four feet are stable and
resting on the floor, adjusting them as
required, and check that the appliance is
perfectly to level using a spirit level.
If the appliance is being installed on
wood or "floating" floors (certain parquet
and laminate materials), secure a 60 x 60
x 3 cm (at least) sheet of plywood to the
floor then place the appliance on top of
this.
Connect the water inlet hose(s) to
the water supply in accordance with the
regulations of your local water company.
The washing machine is fitted with
transport bolts to prevent any possible
damage to the interior during transport.
Before using the machine, it is imperative
that the transport bolts are removed.
After their removal, cover the openings
with the 4 enclosed plastic caps.
Make sure that the ventilation openings
in the base of your washing machine
(if available on your model) are not
obstructed by a carpet or other material.
Use only new hoses to connect the
appliance to the water supply. The old
hose-sets should not be reused.
The supply water pressure must be in
the 0.1-1 MPa range.
Do not repair or replace any part of the
appliance unless specifically stated in the
user manual. Use only authorized Stores.
Self or non-professional repair may lead
to dangerous incident resulting in live
or health threatening and/or significant
property damage.
The spare parts for the household
machine will be available for 10 years
after placing the last unit on the market
as dictated by the European Ecodesign
regulation.
6