IKEA UDDARP AA-2307002-2 Bedienungsanleitung Seite 16

ENGLISH
CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER
Switch off and unplug the washing machine before cleaning
the water filter or draining residual water. If you used a hot
wash programme, wait until the water has cooled down before
draining any water.
Clean the water filter regularly, to avoid that the water cannot
drain after the wash due to obstruction of the filter.
If the water cannot drain, the display indicates that the water
filter may be clogged.
1. Remove the kick panel:
using a screwdriver, do that which is shown in the following
figure.
2. Container for the drained water:
place a low and wide container under the water filter in
order to collect the residual water.
3. Drain the water:
slowly turn the filter counter-clockwise until all the water
has come out. Allow the water to flow out without removing
the filter. Once the container is full, close the water filter by
turning it clockwise. Empty the container.
Repeat the procedure until all the water has been drained.
4. Remove filter:
lay a cotton cloth beneath the water filter, which can absorb
a small amount of rest water. Then remove the water filter
by turning it out anticlockwise.
5. Clean the water filter:
remove residues in the filter and clean it under running
water.
6. Insert the water filter and reinstall the plinth:
reinsert the water filter again by turning it in clockwise
direction. Make sure to turn it in as far as it goes; the filter
handle must be in vertical position. To test water tightness
of the water filter, you can pour about 1 liter of water into
the detergent dispenser.
Then reinstall the plinth.
16