Erwin Sattler Rotalis Bedienungsanleitung Seite 96

3.
Motor 01 – Motor..., (The motor number matches to the specific watch winder model)
The values of the selected watch are transferred to the fields. In addition, changes can
be made by overwriting the values. These changes can be transferred to the watch
winder, but are not changed in the database.
4.
Light: The light of the watch winder can be set to on, off and interval (the light
switches on automatically when the winders are turning) here. Exception Rotalis 3: if
the light is on, it automatically switches to interval after 1 hour. This is to reduce the
power consump-tion of the battery.
5.
Restart: This button can be used to enter a desired new start date (restart date). The
new start date is calculated in hours from the time of data transfer. For example, if a
restart of 10 hours is entered and transmitted at 10:00 p.m., the restart is carried out at
8:00 a.m. on the following day. The W-LAN module can also be switched off here.
Please note that data transfer is not possible with the WIFI module switched off. This
can be reactivated after a brief interruption in voltage (disconnect and reconnect the
power pack).
6.
Open: The watch winder glass pane(s) of the Rotalis 15 - 60 models can be opened via
WIFI here. (does not apply to Roatlis 3, Rotalis 6 Wood and Rotalis 10 Wood.
7.
Data: With the "Save" button, the settings are transferred to the watch winder and
saved.
Attention:
If the settings are changed and the data transfer has not been completed, the data in the
control unit may not be the same as is shown on the screen.
42