Erwin Sattler Rotalis Bedienungsanleitung Seite 101

3. Open the watch winder units
Scan a valid userfinger over the sensor
• Access is granted -> the green LED is on and the relay is connected
• Access is denied -> the red LED is on
4. Delete userfingers
D Enter the program mode by scanning the masterfinger
• Red and green LED are on for a short time
D Press the button »D« on the remote control – the red LED is two times on
for a short time
Enter the ID of the userfinger(s) to be deleted and press the button »OK«
D
to confirm – green LED is on shortly
D Close the program mode by scanning the masterfinger
• red and green LED are on for a short time
5. Delete all fingers (incl. masterfinger) at the control unit
5.1 The recommended way to delete all fingers is via reset code:
Erase-code (see page 51)
•
Hold the infrared remote control directly in front of the fingerprint reader:
Press: DA Erase-code
D
After that, the fingerprint reader is set to default settings (red + green + blue LED light
up continuously)
Changing the reset code:
D D E D old code
5.2 Scan masterfinger 3 times.
After the 2nd time the red LED will start to blink to indicate the delete mode will be
activated with one more scan of the master finger.
After the 3rd time the masterfinger has been scanned, the green LED will be blinking
• to indicate the deletion process is active.
When deletion has finished all LEDs are on.
The device is in the delivery condition – the red, green and blue LED are on permanent
5.3 IIf there is no master finger or reset code available,
the device can only be reset to default setting in the interior of the watch winder.
This procedure should only becarried out by qualified personnel.
• Press delete button of the control unit (internal) for some seconds until LED on the
control unit starts to blink.
• The green LED on finger print reader unit will blink for approx. 30 sec.
• The device is in the delivery condition – the red, green and blue LED are
on permanent.
OK.
D
D OK D new code D OK
47