Erwin Sattler Rotalis Bedienungsanleitung Seite 65

Starting up your Rotalis 6 Wood watch winder
Please unpack your watchwinder carefully (removing the packaging material provided for
transporting again.
Please plug in the power supply using the supplied power pack (please use this only).
After connecting the Rotalis 6 Wood to the power supply, the watch winder units start auto-
matically.
The watch winder now runs with the preset programming. With this programming, more
than 80% of all automatic movements are wound up reliably and gently without the need for
further settings.
The software of the Rotalis 6 Wood is designed in such a way that it follows the daily routine
of a watch wearer and thus has an avtive and a sleeping phase.
With the »initial start-up« you can specify the desired daily period in which the watch
winder should turn. For example, if you start (plug in the power supply) the Rotalis 6 Wood
for the first time at 8 a.m., the clocks start moving every day from 8 a.m. for 16 hours.
From this point on, the watch winder units will then function from 8 o'clock in the morning to
12 midnight every day so that they can then have a sleeping phase lasting 8 hours. During this
sleeping phase, the mainspring in the wristwatch is slackened to allow the watch to function
in an optimum operating range.
To change the start time, switch off your Rotalis 6 Wood and switch it on again at the desired
start time. Or use the »Restart« function in Smart Interface.
In order to optimally wind the wristwatch, we recommend programming the winder
individually.
11