Erwin Sattler Rotalis Bedienungsanleitung Seite 77

Installation of the Rotalis 24
The Rotalis 24 is only to be installed by qualified pesonnel. For any question, please contact
your local jeweller or the Erwin Sattler company directly.
Starting up your Rotalis 24
Please plug in the power supply. After connecting the Rotalis 24 to the power supply,
the watch winder units start automatically.
The watch winder now runs with the preset programming. With this programming, more than
80% of all automatic movements are wound up reliably and gently without the need for further
settings.
The software of the Rotalis 24 is designed in such a way that it follows the daily routine of a
watch wearer and thus has an avtive and a sleeping phase.
With the »initial start-up« you can specify the desired daily period in which the watch winder
should turn. For example, if you start (plug in the power supply) the Rotalis 24 for the first
time at 8 a.m., the clocks start moving every day from 8 a.m. for 16 hours. From this point
on, the watch winder units will then function from 8 o'clock in the morning to 12 midnight
every day so that they can then have a sleeping phase lasting 8 hours. During this sleeping
phase, the mainspring in the wristwatch is slackened to allow the watch to function in an
optimum operating range.
To change the start time, switch off your Rotalis 24 and switch it on again at the desired start
time. Or use the »Restart« function in Smart Interface.
In order to optimally wind the wristwatch, we recommend programming the winder
individually.
Open the glass pane
The Rotalis 24 is equipped with 1 glass pane made of mirrored saftey glass. The glass pane
can be opened with:
1.
fingerprint reader
2. with the including key, you can find the lock behind the sliding panel at the right side
(see at the following page)
3.
Smart Interface
Functions behind the left sliding panel
Upper button
To close the window hold on tight the upper button,
until the glass pane has completely closed.
Lower button with double function
Light on / off:
Switch the light on and off:
Press the button once briefly
Open the flap:
Press and hold the button until a click is heard.
Caution: Do not drop the flap downwards.
23