Lock Mode; Check If An Id Is Already Assigned - Erwin Sattler Rotalis Bedienungsanleitung

6. Lock mode

Blocking:
D
If a finger which is not enrolled, is scanned over the sensor 5 times (red LED is ON),
the module will be switch to lock mode. This will stop unauthorised users from
unlimited trials to access the system.
• IIf the system is in lock mode, the red LED is blinking. Initially the mode is only
temporary for 1 minute but will extended with every 5 faulty attempts to access.(Lock
intervals: 1 minute, 5 minutes, 30 minutes, 60 minutes, permanent).
Unlock:
D
Lock mode can be ended prematurely by swiping a registered finger (master finger
or user finger) over the sensor two times directly after one another.

7. Check if an ID is already assigned

D Press button »OK«
D Enter the ID to be checked
D Press button »OK«
• If the ID is already assigned both LEDs (red and green) are on
• If the ID has not yet been assigned, only the red LED lights up.
Please notice:
1. The blue LED indicates that the device is powered on (blue LED is on permanently)
2. Some useful hints for getting better fingerprint when scanning the finger
over the sensor:
D Slide your finger with a constant speed and slightly pressure over the sensor
The area of the finger that contacts with the line sensor should be as large
D
as possible (Refer to the figure below).
Right
48
Wrong