Battery Change; Technical Data - Erwin Sattler Rotalis Bedienungsanleitung

Now you can push the watch with closed bracelet over the watch holder. For better handling
the watch holder can be compressed. In order to secure the watch, the watch holder will
expand to the width of the wristband.
Replace the watch holder in the housing of the winder.
Please make sure that the watches are always set at 12 o´clock position when inserted. They
will return to this position after each winding interval.
End of Life – display of the batteries
The Rotalis 3 is equipped with an End of Life display of the batteries. If the capacity of the
monocells slowly decreases, the LED's start to flash and the clock winders turn jerkily.
The batteries should be changed soon.

Battery change

Open the three crosshatch screws of the battery cover at the bottom and press »Push«.
The ground rises and can be removed to change the batteries.
Please ensure that the batteries are inserted correctly.
Technical Data: Rotalis 3
Case Solid wood case, side panels: stainless steel or Staron,
LED illumination,
Height: 17 cm, Width: 33 cm, Depths: 20 cm
Crystals Front crystal made from safety glass, open forward
Winders 3 precision watch winders, individually programmable,
12 o'clock position
Drive 3 high-power motors
Ball bearings 18 stainless steel precision ball bearings
Data transfer WIFI
Power supply 2 mono cells and connection for power supply
9