Technical Data - Erwin Sattler Rotalis Bedienungsanleitung

Now you can push the watch with closed bracelet over the watch holder. For better handling
the watch holder can be compressed. In order to secure the watch, the watch holder will
expand to the width of the wristband.
Replace the watch holder in the housing of the winder.
Please make sure that the watches are always set at 12 o´clock position when inserted.
They will return to this position after each winding interval.
Technical data: Rotalis 30
Case
Crystals
Winders
Drive
Ball bearings
Clock
Nautical instruments Thermometer, Barometer
Equipment
Power supply
Height: 200 cm (with extended panes 238 cm),
Width: 145 cm, Depths: 20 cm
Safety glass, mirrored
30 precision watch winders, individually programmable via WIFI,
12 o'clock position
30 high-power motors
180 stainless steel precision ball bearings
Navis 24
4 side boxes with 48 cushions for hand-winding watches
110–230 V,
If an individual adjustment to the
respective movement is to take place,
this can be done by using the integrated
software (SMART INTERFACE).
How to use the software is described in
chapter »Manual for the software
SMART INTERFACE«
see page 38.
The ship clock and the nautical
instruments are described
at the pages 34 to 37.
29