Erwin Sattler Rotalis Bedienungsanleitung Seite 85

Installation of the Rotalis 60
The Rotalis 30 is only to be installed by qualified pesonnel. For any question, please contact
your local jeweller or the Erwin Sattler company directly.
Starting up your Rotalis 60
Please plug in the power supply. After connecting the Rotalis 60 to the power supply,
the watch winder units start automatically.
The watch winder now runs with the preset programming. With this programming, more than
80% of all automatic movements are wound up reliably and gently without the need for further
settings.
The software of the Rotalis 60 is designed in such a way that it follows the daily routine of
a watch wearer and thus has an avtive and a sleeping phase.
With the "initial start-up" you can specify the desired daily period in which the watch winder
should turn. For example, if you start (plug in the power supply) the Rotalis 60 for the first
time at 8 a.m., the clocks start moving every day from 8 a.m. for 16 hours. From this point on,
the watch winder units will then function from 8 o'clock in the morning to 12 midnight every
day so that they can then have a sleeping phase lasting 8 hours. During this sleeping phase,
the mainspring in the wristwatch is slackened to allow the watch to function in an optimum
operating range.
To change the start time, switch off your Rotalis 60 and switch it on again at the desired start
time. Or use the »Restart« function in Smart Interface.
In order to optimally wind the wristwatch, we recommend programming the winder
individually.
Open the glass panes
The Rotalis 60 is equipped with 2 glass panes made of mirrored saftey glass. The glass
panes can be opened with:
1. fingerprint reader
2. with the including key, you can find the lock behind the sliding panel at the right side
(see at the following page)
3.
Smart Interface
Functions behind the left sliding panel
Upper button
To close the window hold on tight the
upper button, until the glass panes have
completely closed.
Lower button with double function
Light on / off:
Switch the light on and off:
Press the button once briefly
Open the flap:
Press and hold the button until a click is heard.
31