Detailed Description; Enrollment Of Userfingers Associated With An Id - Erwin Sattler Rotalis Bedienungsanleitung

Detailed description

1. Masterfinger enrollment
After activating the device for the first time or after reset to default settings, a masterfingers
has to be enrolled (different masterfingers are possible).
The need of the masterfinger enrollment is indicated by the red, green and blue LED are on at
the same time.
To enroll, the finger has to be scanned over the sensor. When successful, the red and
green LED ,are on for a short time to confirm the storage process.The fingerprint is stored
automatically.
Scan the masterfinger 6 x
If the masterfinger enrollment was successful, the red and green LED are off the blue LED
is on.
2. Enrollment of userfingers associated with an ID
A
Enter the programming mode by scanning the masterfinger.
B
Red and green LED are on for a short time.
C
Press button »E« (Enrollment) on the remote control.
D
Enter unused ID (0, 1, 2...150) via remote control.
E
Confirm with »OK«.
Enroll one or more user fingers. (pull over the sensor several times)
F
If enrollment was successful the green LED is on. Always wait until the green LED goes
G
out before reading in the finger again.
H
If quality was not sufficient the red LED is on. To optimize the recognition rates,
every user finger is supposed to be scanned 3x.
I
All fingers are saved to the entered ID.
J
Close the program mode by scanning the masterfinger.
• Red and green LED are on for a short time
It is possible to save several userfingers with one ID. But all actions related to this ID,
D
like disable access or deletion will affect to all userfingers with this ID.
• For fingers which are difficult to register (e.g. those of small children or people with
very dry skin), it may be necessary to scan the user finger up to six times or use a
different finger as the user finger.
• If the program mode is not closed within 10 sec. after last enrollment of a userfinger ,
the process will quit without saving the last userfinger.
46