Replacing The Lamp; Closing The Door - Electrolux SG220N Benutzerinformation

Problem
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
The Super Freeze function
is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The Super Freeze function
is switched on.
There is no cold air circula‐
tion in the appliance.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Switch off the Super
Freeze function manually,
or wait until the function
deactivates automatically
to set the temperature. Re‐
fer to the "Super Freeze
function" section.
Set a higher/lower temper‐
ature.
Refer to the "Closing the
door" section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to the "Super Freeze
function" section.
Make sure that there is
cold air circulation in the
appliance. Refer to the
"Hints and tips" chapter.
73