Replacing The Lamp; Closing The Door; Installation - Electrolux EC2830AOW2 Benutzerinformation

14 www.electrolux.com
Problem
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
9. INSTALLATION
WARNING!
Refer to Safety chapters.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Possible cause
The appliance is in dem-
onstration mode.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
The FastFreeze function is
switched on.
There is no cold air circu-
lation in the appliance.

8.3 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Climate
class
SN
N
ST
T
Solution
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C