syr HygBox Connect Anleitung Zur Montage, Inbetriebnahme, Bedienung Und Wartung Seite 49

Example 2:
Operating mode: cold / start temperature: 25 °C / stop temperature: 20 °C / max. flush time: 2
min. / max. number of flushings per day: 5
The temperature of 25 °C is exceeded. The HygBox activates a temperature flushing. If a tem-
perature of 20 °C is reached within 2 min, the flushing stops. If the temperature of 20 °C fails
to be reached within 2 min., an error message appears and flushing stops. If the device flushes
more than 5 times within 24 hours, the device activates an alarm and will not flush again for
24 hours.
Start temperature:
Defines the temperature above or below which flushing is activated.
Stop temperature:
Defines the temperature at which flushing stops.
Max. flush time:
Indicates the maximum flush time. If the target temperature fails to be reached within the
flush time, flushing stops and an alarm is given.
Cyclic flushing
The "cyclic flushing" function activates a flush in a definable interval. The flush volume can Setting parameters
also be defined. The flush time is calculated in the same way as for stagnation flushing. Any
Interval:
water volume that has flown between intervals will not be considered.
10 min. - 30 days
Example:
Flush volume
Interval: 6 hours / flush volume: 30 liters
1l - 100l
Interval:
Specifies the time between flushing.
Flush volume:
The flush volume is the volume that is flushed after the interval.
Manual flushing
Manual flushing is only intended for commissioning and can only be activated directly on the
device.
Flushing can be activated by pressing the button as follows: Press and hold the button for
approx. 3 seconds until the LED lights up green.
The flush time is 1 minute.
During flushing, the LED flashes in yellow. To cancel the flush, the same button function can be
used as for starting the flush.
Assembly, commissioning, operation and maintenance HygBox Connect