Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General
E
N
G
L
I
[VOL}] [VOL{] (Volume) [DISP] (Display)
S
H
3
REM OTE
CH· C
1 2
[HDB]
PTY
(S•HDB)
[MUTE]
Turn the key in the ignition until the accessory
indicator lights.
Power
ON : Press [SOURCE] .
OFF : Press [SOURCE] again and hold for more than 1
second.
A security message is displayed, and the warning
alarm that reminds you to take the panel off.
(When S-LED is set to ON
a
page 24)
Note: When ACC selection is set to ON, security mes-
sage and panel removal alarm are performed after turn-
ing off the ignition key. (
a
page 24 about ACC selection)
Source
Press [SOURCE] to change the source.
Radio
Cassette Tape
(When a cassette is in the player)
CD Changer
(When a CD changer is con-
nected and magazine is in the
changer)
Auxiliary
DAB
(When DAB tuner is connected
(When AUX-IN setting is set to
a
for DAB control, please refer
ON)
(a
to the attached Operation Guide
for CY-DAB2000N)
6
CQ-FX721N
[DIM] (Dimmer)
Note : When you use this unit for
the first time, a demonstration
message appears on the display.
To cancel this display, press
[DISP] .
[SOURCE]
(Power)
Volume
[VOL}] : Up
[VOL{] : Down
Setting Range : 0 to 40
Note : The sound level for each source is
stored in memory.
(For radio, one volume setting for AM, one vol-
ume setting for all FMs)
[SOURCE] (Power)
[VOL}] [VOL{]
(Volume)
[MUTE]
Mute/ATT (Attenuation)
MUTE/ATT ON : Press [MUTE] .
MUTE/ATT OFF : Press again.
Decreasing volume range depends on setting.
a
(MUTE/ATT setting
page 24)
: No sound
: Decrease the volume to
page 24)
1/10 of previous level.
Dimmer
Press [DIM] on the main unit to change the dimmer level.
DIMMER 3
DIMMER 2
DIMMER 1
Display Change
Press [DISP] .
Mode Display
[DISP] (Display)
Display OFF *2
Notes :
¡Set the Spectrum Analyzer pattern in a separate procedure.
¡"NO CT" is displayed before adjusting the clock. (Adjustment
Active Indicator Display
Press and hold [DISP] for more than 2 seconds.
Indicators which are not displayed on Mode Display are displayed.
Press [DISP] again to cancel.
Press [DISP] .
Clock Display
(Back light is on)
Note : See page 24 about ACC Selection setting.
Super High Definition Bass
(S•HDB)
(Brighter) (Default)
Especially for rock music, the bass-sound will be more
powerful.
Press [HDB] on the main unit to change the Super High
(Medium)
Definition Bass on.
•
S
HDB OFF
(Darker)
S
•
HDB BOOM
S
•
HDB TIGHT
When Power is ON
Mode & Spectrum
Analyzer Display
Spectrum Analyzer Display *1
Mode & Clock Display
(a
page 22)
a
page 22)
AUDIO Indicator
When Power is OFF (when ACC Selection is set to ON)
Display OFF
(Back light is off)
E
N
G
L
I
S
H
4
The bass sound of the speakers
are strongly emphasized.
The bass sounds of the speakers
are moderately emphasized. (The
sounds of the Sub-Woofer can be
heard clearly.)
*1 If you press a button, the
Mode & Spectrum Analyzer
Display appears for 5 sec-
onds.
*2 If you press a button, the
light is turned on, the Mode
Display appears, and the
light is turned off approxi-
mately 5 seconds later.
7
CQ-FX721N
Werbung
Inhaltsverzeichnis
