Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
E
N
G
L
I
S
Preparation
H
23
¡Before installation, check the radio operation with anten-
na and speakers.
¡Disconnect the cable from the negative (–) battery termi-
nal (see caution below).
¡Unit should be installed in a horizontal position with the
front end up at a convenient angle, but not more than
30°.
30° or less
Caution: Do not disconnect the battery terminals of a
car with trip or navigational computer since all user set-
tings stored in memory will be lost. Instead take extra
care with installing the unit to prevent shorts.
Dashboard
Installation
Installation Opening
182 mm
The unit can be installed in
any dashboard having an
opening as shown at right. The dashboard should be 4.5
mm - 6 mm thick in order to be able to support the unit.
Installation Precautions
This product should be installed by a professional installer,
if possible.
In case of difficulty, please consult your nearest authorized
Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery
system (car) with negative ground.
2. Follow the electrical connections carefully (
a
Failure to do so may result in damage to the unit.
3. Connect the power lead (red) after all other connections
are made.
4. Be sure to connect the battery lead (yellow) to the posi-
tive terminal (+) of the battery or fuse block (BAT) termi-
nal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation
instructions of the respective equipment before connect-
ing it to this unit.
26
CQ-FX721N
Supplied Hardware
No.
Item
q
Mounting Collar
w
Mounting Bolt (5 mmø)
e
Power Connector
r
Removable Face Plate Case
t
Trim Plate
y
ISO Antenna Adapter
u
Remote Control
i
Lithium battery (CR2025)
(a) Using the Rear Support Strap (Option)
53 mm
Fire Wall of Car
3 mmø
Tapping Screw (Option)
Hex. Nut (Option)
Rear Support Strap (Option)
wMounting Bolt
qMounting Collar
Page 30).
(b) Using the Rubber Cushion (Option)
Rear Support Bracket
(Provided on the car)
Rubber Cushion
(Option)
wMounting Bolt
qMounting Collar
¡We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
Diagram
Q'ty
¡When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and
fingers.
1
First complete the electrical connections, and
1
then check them for correctness.(
1
1
1
1
1
1
Lock Lever (C C )
Power Connector e
Make sure that the lock lever ( C )
is flush with the mounting collar
(not projecting outward).
Insert Mounting Collar q into the
1
dashboard, and bend the mounting
a
Page 30)
tabs out with a screwdriver.
Mounting Tabs
Mounting Bolt w
Secure the rear of the unit.
2
After fixing Mounting Bolt w and Power
Connector e, fix the rear of the unit to the car
body by either method (a) or (b) shown on the
previous page.
3
Insert Trim Plate t.
After installation reconnect the nega-
4
tive (–) battery terminal.
Lock Lever
CQ-FX721N
E
N
G
L
I
S
H
24
27
Werbung
Inhaltsverzeichnis
