Start The Engine - Athena GET WIFI-COM HONDA Handbuch

2.

Start the engine:

WiFi-COM HONDA will
be powered. After a few
moments, the red and green
LEDs will turn on, indicating a
correct power supply and that
the WiFi signal is activated.
ATTENTION:
- If the LEDs start to flash, this indicates an error. Make
sure to have correctly carried out the preliminary
operations indicated above. Then turn the motorcycle
off and back on again to restart the device.
- If you want to operate the device keeping the
engine off, GET developed a specific wiring for
WiFi-COM Honda (GL-0169-AA), sold separately,
which permits powering WiFi-COM Honda by
connecting it to a completely charged 12 V battery.
3.
Access the phone/tablet
settings and connect
to the WiFi network
indicated on the label on
the back of the device and
at the end of this manual.
Enter the password
located on the label to
establish the connection
between WiFiCOM HONDA
and the phone/tablet.
EN 8
ATTENTION:
- If the WiFi signal is lost, make sure that WiFi-COM
HONDA is on and connected to the phone/tablet.
- The connection between the phone/tablet
and WiFi-COM HONDA is only possible within a
maximum distance of 5 meters. A greater distance
will slow down the communication between the
devices or cause a total loss of connection.
- A failed connection between the phone/tablet
and WiFi-COM HONDA may be also due to poor
weather conditions.
4.
Start WiGET app on your
phone/tablet. Discover how
to use all the functions of
the WiGET app by watching
this video: https:/ /www.
youtube.com/watch?v=P_
RHvewtHSs
NOTE: this video is the tutorial referred to the Wifi-COM
developed for GET ECUs. Some minor differences occur with
the specific Wifi-COM for Honda OEM ECU: the editable
power maps are Map 2 and 3 (MODE 2 / MODE 3). It is
possible to modify FUEL and IGNITION, edit single or multiple
breakpoints, or to restore factory ECU data.
ATTENTION: GET WIFI-COM HONDA WORKS ONLY
WITH HONDA OEM ECUs.
9 EN