Transferring The Configuration To The Transceiver - Werma AndonWIRELESS Handbuch

2. Select the status of the individual tiers of the signal tower.
EN
Status
Show tier 1 state
Show tier 2 state
Show tier 3 state
Show tier 4 state
Show tier 5 state
Permanent Off
Permanent On
Pass signal input
The Configuration examples (see "Configuration examples", S. 73) shows a few examples of
possible practical configurations.
5.2.3 Transferring the configuration to the Transceiver
When the configuration is complete, the settings can be transferred to the Transceiver.
1. Click on Save to device.
The configuration is transferred to the Transceiver.
When the transfer is complete, the current configuration can be transferred to other Trans-
ceivers.
2. Click on Yes to transfer the current configuration to other Transceivers, see "Transferring the con-
figuration to other Transceivers", S. 66.
3. Click on No to configure another AndonWIRELESS device.
4. Remove the USB cable from the Transceiver.
Transferring the configuration to other Transceivers
1. Remove the USB cable from the Transceiver.
2. Connect the other Transceiver to the computer.
3. Click on Save to device.
66
Description
– Display the status of the 1st tier.
– Display the status of the 2nd tier.
– Display the status of the 3rd tier.
– Display the status of the 4th tier.
– Display the status of the 5th tier.
– Switch off the tier permanently.
– Switch on the tier permanently.
– Loop through the input signal.