Environmentally Responsible Disposal - Maico WS 75 NH Installationsanleitung

8 Replacing PTC heat register
6. Insert the PTC heat register module into the
two slots in the EPP housing and secure it
with the two plastic locking pins (arrows)
provided.
7. Make a 90° elbow in the connecting cable and
thread the cable from pos. ② to pos. ③. Ob-
serve arrows in EPP housing.
8. Make a 90° elbow in the connecting cable and
thread the cable from pos. ③ into the elec-
tronics compartment. Observe arrows in EPP
housing.
8
9. Connect the connection cables to the spring
terminal X5 of the main circuit board → Wiring
diagram [} 14].
10.Insert both EPP sealing plugs into the EPP
housing.
11.Install the cover, electronics compartment and
front cover.
12.Attach housing cover.
13.Perform function test via the switching test
function . Using the commissioning soft-
ware, set the Supply air heat register para-
meter to on in the main menu Settings/Switch-
ing test. After a short time the supply air fan
starts. When functioning correctly, heated air
flows out of the supply air opening. Set Supply
air heat register parameter to off.
8 Replacing PTC heat register
1. Powerbox H: Remove WS 75 APA/UPA/
UPGA cover. Powerbox S: Remove any
cover that may be present.
2. Remove the cover of electronics compartment
(2 screws).
3. Remove the two plastic locking pins on the
PTC heat register module and pull the module
out of the EPP housing.
CAUTION Risk of burning on hot PTC
heat register or hot housing parts.
Only touch the heat register or housing parts
when they have cooled down.
4. Disconnect the wiring of the PTC heat register
and pull the connecting cable out of the cable
duct.
5. Install new PTC heat register as described in
the previous chapter.
Only use genuine components.
9 Environmentally responsible
disposal
Old devices and electronic components may
only be dismantled by specialists with elec-
trical training. Proper disposal avoids detri-
mental impact on people and the environment
and allows valuable raw materials to be reused
with the least amount of environmental impact.