Initial Start-Up - Bwt Rondomat Duo-Dvgw 2 Einbau- Und Bedienungsanleitung

EN
l / h
Current softened water supply
40
Time
7

Initial Start-up

Check that the unit has been properly installed.
Units 6 and 10 only:
T he unit may not be started for at least one hour after filling the
disinfectant solution (see Installation).
Open the water supply slowly and plug in mains plug.
The display shows BWT followed by the Regeneration screen.
The current water flow, the time and the regeneration procedure are
shown here.
Cancel regeneration.
Press the Browse button
Set the cursor to Manual
Press OK
Set the cursor to Cancel regeneration
Press OK to confirm for 1. Column
Press OK to confirm for 2. Column
Regeneration is cancelled.
Press the Browse button twice
The current water flow, the time and the supply of softened water are
now displayed.
See the following page for further Start-up steps