Iluminarc LOGIC MR16 Downlight S Schnellanleitung Seite 4

EN
Between LΩGIC Drive 2X and LΩGIC POE X:
Short cables may use a smaller gauge, but any cable longer than 50 ft (15 m) must be 23 AWG and shielded, or the
products may not receive enough power.
Cable requirements: Max/Min gauge of 23/28 AWG CAT6 4 twisted pair.
• For distances less than 50 ft (15 m): 23-28 AWG (shielded or unshielded)
• For distances from 50-328 ft (15-100 m): 23 AWG (shielded)
OUTPUT Port
The OUTPUT port of the LΩGIC POE X allows up to 75 ft (23 m) of total cabling between the LΩGIC POE X and the final
LΩGIC MR16 Downlight S in the chain. These cables can be 23-28 AWG (shielded or unshielded).
THRU Port
The THRU port of the LΩGIC POE X only passes the control signal from the LΩGIC Drive 2X, no power. A POE injector
must be used BEFORE the first LΩGIC product in the chain to power it and further products connected to this port.
LΩGIC DRIVE 2X
A POE injector must be
used between the THRU
port of the LΩGIC POE X
and the first connected
LΩGIC product
POE injector
LΩGIC product
To further LΩGIC products
Mounting
Before mounting this product, read the
Pendant Mounting
Hanging pendant bracket
3
QUICK REFERENCE GUIDE
LΩGIC POE X
INPUT THRU OUTPUT
Safety Notes.
Safety cable
LΩGIC MR16 Downlight S
LΩGIC MR16 Downlight S
LΩGIC MR16 Downlight S
LΩGIC MR16 Downlight S
LΩGIC MR16 Downlight S
LΩGIC MR16 Downlight S
LΩGIC MR16 Downlight S
LΩGIC MR16 Downlight S
POE injector
INPUT
must be used after every 8th
LΩGIC
THRU
LΩGIC MR16 Downlight S
POE X
OUTPUT
LΩGIC MR16 Downlight S
To further LΩGIC MR16 Downlight S products
LΩGIC MR16 Downlight S QRG Rev. 5
Up to 75 ft (23 m) of total
cabling between the
OUTPUT port of the
LΩGIC POE X and the final
LΩGIC MR16 Downlight S
in the chain
A POE injector AND an
additional LΩGIC POE X