Circular Saw Safety Warnings - Makita 5704R Betriebsanleitung

ENGLISH
(Original instructions)
1 A typical illustration of proper
hand support, workpiece sup-
port, and supply cord routing (if
applicable).
2 To avoid kickback, do support
board or panel near the cut.
3 Do not support board or panel
away from the cut.
4 Lever
5 Clamping screw
SPECIFICATIONS
Blade diameter
Max. cutting depth
No load speed (min
Overall length
Safety class
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
All manuals and user guides at all-guides.com
Explanation of general view
6 Base
7 Cutting line
8 Setting protuberances
9 Hex socket head bolt
(For adjusting riving knife)
10 Cutting depth
11 Switch trigger
12 Lock-off button
13 Hex wrench
14 Shaft lock
Model
at 90°
at 45°
–1
)
Net weight
ENE028-1
ENF002-2
GEA010-1
15 Hex socket head bolt
16 Outer flange
17 Saw blade
18 Inner flange
19 Vacuum cleaner
20 Rip fence (Guide rule)
21 Limit mark
22 Brush holder cap
23 Screwdriver
190 mm
345 mm

CIRCULAR SAW SAFETY WARNINGS

Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on auxil-
iary handle, or motor housing. If both hands are
holding the saw, they cannot be cut by the blade.
2. Do not reach underneath the workpiece. The
guard cannot protect you from the blade below the
workpiece.
3. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
4. Never hold piece being cut in your hands or
across your leg. Secure the workpiece to a sta-
ble platform. It is important to support the work
properly to minimize body exposure, blade binding,
or loss of control. (Fig. 1)
5. Hold the power tool by insulated gripping sur-
faces only, when performing an operation where
the cutting tool may contact hidden wiring or its
own cord. Contact with a "live" wire will also make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
6. When ripping, always use a rip fence or straight
edge guide. This improves the accuracy of cut and
reduces the chance of blade binding.
7. Always use blades with correct size and shape
(diamond versus round) of arbor holes. Blades
that do not match the mounting hardware of the saw
will run eccentrically, causing loss of control.
8. Never use damaged or incorrect blade washers
or bolt. The blade washers and bolt were specially
designed for your saw, for optimum performance and
safety of operation.
5704R
66 mm
46 mm
4,900
4.9 kg
/II
GEB029-5
5