Safety Instructions - Nuova Simonelli TALENTO Gebrauchsanweisung

EN
2.

SAFETY INSTRUCTIONS

 This book is an integral and essential part
of the product and must be given to the
user. Read this book carefully. It provides
important information concerning safety
of installation, use and maintenance. Save
it carefully for future reference.

After unpacking, make sure the appliance
is complete. In case of doubts, do not
use the appliance, but consult a quali-
fied technician. Packaging items which
are potentially dangerous (plastic bags,
polystyrene foam, nails, etc.) must be
kept out of children's reach and must not
be disposed of in the environment.
RISK OF POLLUTION
 Before connecting the appliance make sure
the rating plate data correspond with the
mains. The nameplate is located on the back
of the machine, on the left-hand side at the
bottom. The appliance must be installed by
qualified technicians in accordance with cur-
rent standards and manufacturer's instruc-
tions.
The manufacturer is not liable for any dam-
age caused due to failure to ground the
system. For the electrical safety of the appli-
ance, it is necessary to equip the system
with the proper grounding. This must be car-
ried out by a qualified electrician who must
ensure that the electric power of the system
is sufficient to absorb the maximum power
input stated on the plate.
All manuals and user guides at all-guides.com



Fig. 3



In particular you must ensure that the size
of the wiring cables is sufficient to absorb
power input.
The use of adapters, multiple sockets or
extensions is strictly forbidden. If they
prove necessary, call a fully qualified elec-
trician.
When installing the device, it is nec-
essary to use the parts and materials
supplied with the device itself. Should
it be necessary to use other parts, the
installation engineer needs to check their
suitability for use in contact with water
for human consumption.
This machine must be installed according
to the applicable federal, state, and local
standards (codes) in force with regard
to plumbing systems including backflow
prevention devices. For this reason, the
plumbing connections must be carried
out by a qualified technician.
The device needs to be supplied with
water that is suitable for human consump-
tion and compliant with the regulations
in force in the place of installation. The
installation engineer needs confirmation
from the owner/manager of the system
that the water complies with the require-
ments and standards stated above.
This appliance must only be used as
described in this handbook. The manu-
facturer shall not be liable for any damage
caused due to improper, incorrect and
unreasonable use.
At the end of installation, the device is
switched on and taken to rated operating
conditions, leaving it in a state in which it
is "ready for operation".
Fig. 4
39