Device Configuration - MADRIX NEBULA Technisches Handbuch

3) Device Configuration

Step 1) Connect MADRIX
Step 2) Assign correct network settings in the computer's operating system.
(Recommended: IP address 10.0.0.1 / Subnet mask 255.0.0.0)
Step 3) Open your web browser and enter the IP address of MADRIX
(You can find the default IP address on the side of the NEBULA device.)
Step 4) The built-in web configuration tool will be launched. Go to 'SPI Output
Configuration' > 'Output Protocol' and choose the LEDs your are
using for 'Port 1' and 'Port 2'. You can choose the output protocol
separately for each of the two ports. Apply changes with 'Set'.
Step 5) Change any other settings as required. Apply changes with 'Set'.
Please note: In order to put MADRIX
correct output protocol according to the LEDs you have connected.
Basic Configuration Using The
®
MADRIX
Step 1) Connect devices to your computer over USB or network, but not both!
Step 2) Make sure to stop sending control data to the devices!
Step 3) Start the MADRIX
Step 4) In MADRIX
confirm or change the network settings and any other settings for your
devices as required.
On a selected device, use Right Mouse Click > 'Open Device
Configuration Via HTTP...' to open the web configuration through a
web browser, as explained above.
On a selected device, use Right Mouse Click > 'Restore Factory
Default Settings' to perform a reset to factory default settings.
For more information, see the MADRIX
The software is available for download from
13
EN
®
NEBULA and your computer to the same network.
HARDWARE MANAGER Software
®
HARDWARE MANAGER Software.
® HARDWARE MANAGER, go to the tab 'Devices' and
® NEBULA fully into operation, set the
®
HARDWARE MANAGER User Manual.
www.madrix.com
® NEBULA.