Remote Device Management (Rdm) - MADRIX STELLA Kurzanleitung & Technisches Handbuch

Device Configuration Through A Web Browser
Step 1) Connect MADRIX
Step 2) Assign correct network settings for your computer in the operating
system. (Recommended default settings:
IP address 10.0.0.1 and Subnet mask 255.0.0.0)
Step 3) Open your web browser and enter the IP address of MADRIX
(You can find the default IP address on the side of the device.)
Step 4) The built-in web configuration tool will be launched.
Step 5) Change any settings as required. Apply changes with 'Set'.
®
MADRIX
Step 1) Connect devices to your computer over USB or network, but not both!
Step 2) Make sure to stop sending control data to the devices!
Step 3) Start the MADRIX
Step 4) In MADRIX
confirm or change the network settings and any other settings for your
devices as required.
On a selected device, use Right Mouse Click > 'Open Device
Configuration Via HTTP...' to open the web configuration through a
web browser, as explained above.
On a selected device, use Right Mouse Click > 'Restore Factory
Default Settings' to perform a reset to factory default settings.
For more information, see the MADRIX
The software is available for download from

Remote Device Management (RDM)

In order to use RDM, call up the built-in web configuration (see above) and go to
'Network To DMX Output' > 'Enable RDM' for ports 'DMX 1' and/or 'DMX 2'.
Make sure to disable RDM on the specific port, when using STELLA for DMX-IN.
Thanks to STELLA's Packet Multitasking, RDM and Art-Net can be sent and
received at the same time and during live operation with a min. frame rate of 22
FPS, an expected average of 34 FPS, and a max. frame rate of 44 FPS, depending
on the number of RDM packets.
9
EN
®
STELLA and your computer to the same network.
HARDWARE MANAGER
®
HARDWARE MANAGER Software.
® HARDWARE MANAGER, go to the tab 'Devices' and
®
HARDWARE MANAGER User Manual.
www.madrix.com
®
STELLA.