Remote Device Management (Rdm) - MADRIX STELLA Handbuch

Device Configuration Through A Web Browser
Step 1) Connect MADRIX
Step 2) Assign correct network settings for your computer in the operating
system. (Recommended default settings:
IP address 10.0.0.1 and Subnet mask 255.0.0.0)
Step 3) Open your web browser and enter the IP address of MADRIX
(You can find the default IP address on the side of the device.)
Step 4) The built-in web configuration tool will be launched.
Step 5) Change any settings as required. Apply changes with 'Set'.

Remote Device Management (RDM)

In order to use it, call up the built-in web configuration (see above) and go to
'DMX Output Settings' > 'Enable RDM' for ports 'DMX 1' and/or 'DMX 2'.
Make sure to disable RDM on the specific port, when using STELLA for DMX-IN.
Daisy-Chain Support
STELLA features 2 separate Ethernet network ports. Either one is fully
functionally for IN and OUT and can be used for the data connection without using
a separate network switch or router. We recommend to connect a maximum
of 40 units after one another in a row, when using Art-Net in Unicast Mode
or Streaming ACN Multicast at a max. data rate of 50 FPS / 20 ms without
any additional devices in the network. In MADRIX
activate ArtSync for excellent image quality (see p. 13).
How To Update The Firmware
It is highly recommended to update the firmware should a new firmware version
become available. You can update the device in different ways, for example:
Step 1) Connect MADRIX
Step 2) Start the MADRIX
Step 3) In MADRIX
A new window will open. Click on the search button (Loupe icon) and
the software will search for connected devices. Select your device in
the list, click on the 'Firmware' button, and follow any instructions.
9
EN
STELLA and your computer to the same network.
®
STELLA to your computer over USB.
®
5 Software.
®
5, go to 'Tools...' > 'MADRIX Device Configuration...'.
®
5, we highly recommend to
®
STELLA.
®