Abicor Binzel ABIPLAS CUT 71 HF Betriebsanleitung Seite 60

11 Disassembly
11 Disassembly
Disassembly may only be carried out by specialist dealers. Please ensure that the shut down
procedures are strictly observed before disassembly begins.
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Consult the documentation for the welding components.
• Note the following instructions:
 8 Putting out of operation on page EN-26.
EN - 30
®
ABIPLAS CUT HF
BAL.0716.0 • 2022-01-11