Abicor Binzel ABIPLAS CUT 71 HF Betriebsanleitung Seite 41

®
ABIPLAS CUT HF
6 Putting into operation
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Switch off the entire welding system.
DANGER
Risk of injury and device damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
NOTICE
• Note the following instructions:
 3 Product description on page EN-5
6.1 Setting up the
6.1.1 Cutting torch body
The ABIPLAS
110 A and 150 A, each based on a duty cycle of 60%. The cutting torch head is positioned at
an angle of 110° to the handle axis. The plasma nozzle, protective cap, swirl ring, electrode
and insulator are all wear parts that can be easily replaced by inserting or screwing on spare
parts. To protect the operator, the screw-on protective cap is equipped with a safety cut-out
mechanism, which will automatically interrupt the inrush current circuit if the protective cap is
removed. Accessories such as torch carriage, circular torch guide, template cutting guide and
spacer can be attached and locked onto the outer contour of the protective caps.
6.1.2 Handle
The ergonomically shaped handle is equipped with a trigger. A trigger guard prevents the
cutting torch being accidentally switched on when laid down.
BAL.0716.0 • 2022-01-11
®
CUT HF manual cutting torch
ABIPLAS
®
CUT HF cutting torch bodies are available in the three output currents 70 A,
6 Putting into operation
EN - 11