Abicor Binzel ABIPLAS CUT 71 HF Betriebsanleitung Seite 59

®
ABIPLAS CUT HF
Fault
Insufficient penetration
Cutting arc breaks
Excess dross formation
Cutting nozzle burned
out
Strong electrode burn-out
Tab. 9 Troubleshooting
BAL.0716.0 • 2022-01-11
Cause
• Pressure drop during cutting
• Cutting rate too high
• Tilt angle of the torch too great
• Material thickness too high
• Equipment parts worn or
damaged
• Output not adjusted
• Cutting rate too low
• Torch clearance too great
• Material thickness too high
• Output too low
• Cutting rate too low or too high
• Equipment parts worn or
damaged
• Output not adjusted
• Damaged or loose nozzle
• Contact with the workpiece
• Start of cut at the edge of the
workpiece too fast
• Too much spatter when punching
holes
• Pilot arc struck too long and too
frequently in the air
• Pilot arc too strong (depends on
the power source)
• Pressure drop while cutting due to
incorrectly set pressure monitor
• Loose electrode
• Pilot arc struck too long and too
frequently in the air
10 Troubleshooting
Troubleshooting
• Reset the pressure monitor
• Reduce the cutting rate
• Reduce the tilt angle
• Use a lower material thickness
• Replace the equipment parts
• Adjust the output
• Increase the cutting rate
• Reduce the torch clearance
• Use a lower material thickness
• Adjust the output
• Adjust the cutting rate
• Replace the equipment parts
• Adjust the output
• Hand-tighten the nozzle or cap
body. Replace the nozzle if
necessary.
• Avoid contact
• Start cutting at a lower rate
• Shorten/avoid ignitions in the air
if possible
• Set the pilot arc current to the
lowest possible value
• Correct the pressure monitor
setting
• Hand-tighten the electrode
• Shorten/avoid ignitions in the air
if possible
EN - 29