Scheppach HS89 Originalbetriebsanleitung Seite 21

Trouble
1. Saw blade comes lose when
turning off the engine
2. Engine cannot be started
3. Wrong direction of rotation
4. Engine does not provide
power, fuse is tripped
5. Burn areas on the cut
surface
Troubleshooting
Possible cause
Fastening nut is not sufficiently tightened
a) Breakdown of the main's fuse
b) Defective extension cable
c) Defective motor or switch connection
d) Defective engine or switch
a) Defective capacitor
b) Incorrect connection
a) Cross-section of the extension cable insufficient
b) Overload caused by a blunt saw blade
a) Blunt saw blade
b) Incorrect saw blade
Solution
Tighten fastening nut (right-hand thread)
a) Check main's fuse
b) Replace extension cable
c) Have the device checked by a qualified electrician
d) Have the device checked by a qualified electrician
a) Have the device checked by a qualified electrician
b) H ave the polarity of the wall socket replaced by
qualified electrician
a) see Electrical connection
b) Replace the saw blade
a) Sharpen or replace the saw blade
b) Replace the saw blade
21
GB