Scheppach HS89 Originalbetriebsanleitung Seite 20

■ ADJUSTING THE SPLITTING WEDGE FIG.16, 17, 18
Loosen the wing nut to remove the saw blade
protection (2).
Remove 8 cross-head screws and remove the
stage centre (6).
Loosen the two cross-head screws.
Adjust the splitting wedge (5) in such a way
that the distance to the saw blade is between
■ REPAIR
Damages to the power tool may only be re-
paired by qualified electricians.
■ STORAGE
Clean the electrical power tool as described in
the section „Cleansing".
Store the electrical power tool and its accesso-
ries in a dark, dry, frost-free and well ventilated
place out of reach from children. The ideal
storage temperature is between 10 and 30°C.
■ TRANSPORTATION
• Before transporting, turn off the electrical
power and to disconnect it from the power
supply.
• Do not carry the device on the table exten-
GB
sions.
• Protect the power tool from impacts, shocks
and strong vibrations e.g. during transport in
vehicles.
• Also secure the power tool against sliding
and tilting.
3 and 5 mm and that it runs parallel to the saw
blade lengthwise.
Re-tighten both screws.
The adjustment has to be checked each time
after changing the saw blade.
WARNING:
WARNING
m
If the main cable or its plug is da-
maged, it has to be replaced by a qualified
electrician in order to avoid danger!
Attach the cable to the cable seat on the
backside of the power tool when it is not used.
Cover the power tool to protect it against dust
and moisture.
Keep the operating instructions with the power
tool.
20
There are no parts inside the electrical
power tool that may be repaired or main-
tained by the operator! Do not open the
electrical tool! In order to have further
maintenance work performed on the tool
take it to a qualified expert!
WARNING
m
Make sure that after performing
cleansing and maintenance works, all pro-
tection devices (if available) are attached
properly and safely. Never use the power
tool without the protective devices!
NOTE: Observe these operating instructions
to check the power tool for possible for wear
and damage before re-using it.