Transport,Storage & Cleaning; Regular Checks - TEUFELBERGER treeMOTION essential Gebrauchsanleitung

7. TRANSPORT,
STORAGE & CLEANING
The load-bearing parts of the harness are
made of Polyester, Polyamid,
Aluminium, Dyneema®
The Cobra buckles are made of:
body: aluminum
rivets, adjuster bar, integrated D-Ring: stainless
steel
clips: brass
anti slide part: polymer
Operating temp range

+50°C to -30°C
Storage and
transportation conditions
X
Compaction
X
Nibbling pests

Ventilation
X
Excessive moisture
X
UV radiation

+15°C to +25°C

Dry and clean environment
X
Sharp edged objects
Maintenance/Cleaning

Water (≤ 30°C)
X
Machine washing

Mild detergent
X
Pressure washer

Gentle hand washing
Clean dirty COBRA® buckles in lukewarm water (if
necessary using neutral soap). Rinse them well. Dry
at room temperature, never in an electric dryer or
near electric radiators. Use only approved household
disinfection liquids not any containing halogen as
needed. The joints of all metal parts must be relu-
bricated with a dry lubricant regularly, particularly
following cleaning (such dry lubri cants perform
their lubricating function even when in a dry state
so that no dust or dirt can cling to it).
Drying

Hang in well ventilated space (≤ 30C)
X
Direct sunlight
X
Applied heat (e.g. fire)
tRanspoRt, stoRaGe & cLeaninG / ReGULaR cHecKs
Disinfection





Corrosive substances
Keep away from corrosive acids, bases, liquids,
vapours, gases etc. Be careful with tree exsudates!
They may be surprisingly aggressive. If you think
damage has occurred as a result of contact with

an agressive substance:
...
OK
1. Quarantine the product and label it in an obvious
X
...
not OK
2. Send as much detail as possible about your
3. Do not use the product again unless the
WARNING
If any part of the harness is to be exposed to chem-
icals, e.g. cleaning materials or hazardous atmos-
pheres, the user should consult the manufacturer
before to determine whether the part is suitable
for continued use.

8. REGULAR CHECKS

Checking the equipment at regular intervals is
absolutely necessary: your safety depends on the
effectiveness and durability of the equipment!
Following each use, the product should be checked
for abrasion and cuts. Also check it for the legibility
of the product labelling! The use of damaged com-
ponents or components subjected to a fall must be
discontinued at once. If there is only the slightest
doubt, the product needs to be retired or subjected
to testing by a competent person.
When using the equipment in occupational health
and safety to EN 365, it must be checked at least
every 12 months and when using to AS/NZS 1891.1 at
least once every 6 months by a duly qualified person
strictly observing the instructions, or else by the
manufacturer, and it must, whenever necessary, be
occasional short term wash
with max. 60°C
Duration (≤ 1 hour)
Ethanol
Rinse after disinfection
Isopropyl alcohol 70%
way so that it can not be used by mistake;
concerns to the manufacturer;
manufacturer replied (in writing) that it may be
returned to service.
15