hanseatic HVBL8506BLMC Gebrauchsanleitung Seite 58

Problem
Appliance
switches itself
off.
Suction force is
weak.
Dust is being
released from
the appliance.
In rare cases this can make a whistling noise initially. This is not
a malfunction and stops after a while.
Troubleshooting table page EN-27
Possible cause
Brush/nozzle
blocked.
Coarse dust filter
blocked. Overheat
protection has been
activated.
Telescopic tube
/ suction hose is
blocked.
Brush / nozzle is not
positioned correctly.
Object is plugging
the nozzle.
Filters are inserted
incorrectly or are
contaminated.
Air by-pass vent is
open.
Filters are inserted
incorrectly or are
contaminated.
Solutions, tips
Actuate On/Off foot switch, pull out
mains plug, clean brush/nozzle.
Actuate On/Off foot switch, pull out
mains plug, leave appliance to cool
for at least 1/2 hour and clean the
coarse dust filter.
Actuate On/Off foot switch, pull out
mains plug, check telescopic tube
and suction hose for blockage, and
clean if necessary.
Position the brush / nozzle
correctly.
Actuate On/Off foot switch, pull out
mains plug, check telescopic tube
and suction hose for blockage.
Remove object.
Insert filters correctly and/or clean.
Close the air by-pass vent.
Insert filters correctly and/or clean.